Bullet Pulling

Standard Bullet Puller Collet

This collet is designed be used with the RCBS Standard Bullet puller to remove bullets from a wide range of cases. Made in USA

Standard Bullet Puller without Collet

The RCBS Standard Bullet Puller safely removes jacketed bullets with its 7/8-inch-14 thread. It is compatible with single-stage reloading presses but is not for rimfire cartridges. Not sure about the powder charge? Need to change bullets? The RCBS...

1 1/2-Inch-12 Bullet Puller

The 1-1/2-inch-12 Bullet Puller quickly removes bullets from loaded ammunition to salvage components with the AmmoMaster-2 or AmmoMaster .50 BMG press. Use with .416 or .50 BMG bullet puller collets (sold separately). The...

1 1/2-Inch-12 Bullet Puller - Collet

This collet allows the quick removal of bullets from loaded ammunition to salvage components when used with the 1-1/2-inch—12 Bullet Puller. Compatible with the AmmoMaster-2 and AmmoMaster .50 BMG press. When used with the 1-1/2-inch—12...

Pow'r Pull Kit

The RCBS Pow'r Pull Kit is an essential tool for any reloader. Featuring a sturdy one-piece body, ergonomic handle, and 3 case-holding chucks that fit cartridges from 5.7x28mm and .22 Hornet to WSM and RUM families, this kit is a must-have for any...

Replacement Chuck Assembly

Looking for a reliable replacement chuck assembly for your RCBS Pow'r Pull? Look no further than this high-quality replacement chuck assembly, designed to fit with your existing Pow'r Pull. With three available case-holding chucks, this assembly can...